No products in the cart.
This product is also available in 120V 208V 277V 480V. Features: Includes 4500 Watt elements Non-simultaneous All residential storage models meet or exceed efficiency requirements of the Department of Energy ASHRAE Standard 90.1 b current standard and the National Appliance Energy Conservation Act of 1987 recent amendment effective April 16 2015 which supercedes all state and local efficiency requirements. Fully Automatic Controls – Fast acting surface-mount thermostats for automatic temperature control. Factory installed sensitive manual reset energy cutoff for safety to prevent overheating. Direct Heat Transfer With Immersed Elements – Transfers heat directly and efficiently to the water. Screw-in style. Factory Installed Hydrojet Total Performance System – Cold water inlet sediment reducing device helps prevent sediment build up in tank. Vitraglas Lining – Bradford White tanks are lined with an exclusively engineered formula that provides superior protection from the highly corrosive effects of hot water. This formula Vitraglas is fto the steel surface by firing at a temperature of over 1600 F. Non-CFC Foam Insulation – Covers the sides and top of the tank reducing the amount of heat loss. This results in less energy consumption improved operation efficiencies and jacket rigidity. Water Connections – 3/4 inch NPT factory installed true dielectric fittings extend water heater life and eases installation Factory Installed Heat Traps – Design incorporates a flexible disk that reduces heat loss in piping and eliminates the potential for noise generation Protective Magnesium Anode Rod – Provides added protection against corrosion for long trouble-free service. Simultaneous and Non-Simultaneous Operation Available – Simultaneous operation indicates when both elements if equipped are being heated at the same time. Non-Simultaneous operation indicates when one element is being heated at a time. Voltages Available – 120V 208V 240V 277V 480V Single Phase or Three Phase Operation Available 277V may only be wired for single phase operation. TP Relief Valve – Installed Design evaluated by UL in accordance with Part 280.707d of HUD Mobile Home Construction and Safety Standards for Energy Efficiency.